Avoiding Feedback with the Stage Mics
The hanging stage mics are a few metres from the chorus, so they pick up a lot of the speakers. That gives little volume before feedback. Each stage set-up also rings at different frequencies. These are the things to do, in order. The first three need no extra equipment.
✅ 1. The basics
- Mute stage mics that you are not using. A muted mic cannot feed back. Mute them in scenes, or with a DCA or mute group.
- Aim the overhead mics at where the chorus stands, with the back of the mic towards the main speakers.
- Hang them as low as sightlines allow. Halving the distance to the singers gives about 6 dB more voice.
- High-pass filter on every stage mic at 150–200 Hz. Below that is mostly rumble, footsteps and speaker spill.
- Keep stage mics out of the foldback and sidefills. Wedges pointed at the chorus are also pointed at the overhead mics.
- Use stage mics as support. Mix them under the radio mics and the natural chorus sound. Ask the chorus to project.
Why fewer open mics helps
Every open mic is another ear listening to the speakers. Each time you double the number of open mics, about twice as much speaker sound goes back round the loop. That is about 3 dB less volume before feedback. 3 open mics are about 5 dB worse than one. 7 open mics are about 8.5 dB worse.
🎚️ 2. Automatic mic mixing (AMM)
- On the QU-32 the AMM only works on channels 1–16.
- Put only the stage mics (ch 1–7) in the AMM. Keep the radio mics out.
- Use gain sharing mode, not the gating (number of mics) mode. Gain sharing turns up the mic nearest the sound and turns the others down without switching them off, so words are not cut short. The total stays at about one open mic.
- It works for speech and for singing. When the whole chorus sings, the mics share the gain equally.
🔔 3. Ring out each stage set-up
The set (flats, cloths, trucks) changes where the stage mics ring, so ring out each set-up and store it in the QU scenes.
- Set up as for the show: set in place, speakers and foldback at show level, the normal mics open, HPFs on.
- Slowly raise one mic until it just starts to ring.
- Find the frequency with the RTA on the QU PEQ screen.
- Cut it on the channel PEQ: narrow, 3–6 dB. Repeat.
- Stop at 3–4 cuts per channel. More cuts make the stage mics sound thin and tinny.
- Store it in the scene. Use recall filters so the scene changes only the stage mic EQ and mutes, not the radio mics or band.
Warning
Test every scene recall in the technical rehearsal. A wrong recall filter can wipe the radio mic settings in the middle of a song.
Use the main LR graphic EQ only for problems that all mics share.
⏱️ 4. Delay the main speakers (optional)
Your ears believe whichever sound arrives first. Without delay, the speakers reach the audience before the actors' real voices, so the voices seem to come from the speakers and you push the level up. If the speakers are held back slightly, the real voice arrives first and the sound seems to come from the stage. Then you can run the stage mics lower.
- Measure from mid-stage to the main speakers.
- Allow 3 ms per metre.
- Add 5–10 ms.
Example: 5 m is about 15 ms, plus 5–10 ms, so set 20–25 ms on the LR output delay. Keep it under 30–35 ms, or the audience hears an echo. This helps the radio mics too.